plsect

Mapdl.plsect(item='', comp='', rho='', kbr='', **kwargs)

Displays membrane and membrane-plus-bending linearized stresses.

APDL Command: PLSECT

Parameters
item

Label identifying the item to be processed. Valid item labels are shown in Table 221: PLSECT - Valid Item and Component Labels below. Items also require a component label.

comp

Component of the item. Valid component labels are shown in Table 221: PLSECT - Valid Item and Component Labels below.

rho

In-plane (X-Y) average radius of curvature of the inside and outside surfaces of an axisymmetric section. If zero (or blank), a plane or 3-D structure is assumed. If nonzero, an axisymmetric structure is assumed. Use a very large number (or -1) for an axisymmetric straight section.

kbr

Through-thickness bending stresses key for an axisymmetric analysis (RHO ≠ 0):

0 - Include the thickness-direction bending stresses.

1 - Ignore the thickness-direction bending stresses.

2 - Include the thickness-direction bending stress using the same formula as the Y

(axial direction ) bending stress. Also use the same formula for the shear stress.

Notes

Calculates and displays the membrane and membrane-plus-bending linearized stresses (as described for the PRSECT command) along a path section [PATH] as a graph. The path section is defined by two points specified with the PPATH command. For linearized stress calculations, the path must be defined with nodes. The path must be entirely within the selected elements (that is, there must not be any element gaps along the path). The total stress (equivalent to the PLPATH display) is also displayed. This command always uses 48 divisions along the path, regardless of the number of divisions defined by PATH.

Portions of this command are not supported by PowerGraphics [/GRAPHICS,POWER].

Table: 221:: : PLSECT - Valid Item and Component Labels