atran

Mapdl.atran(kcnto='', na1='', na2='', ninc='', kinc='', noelem='', imove='', **kwargs)

Transfers a pattern of areas to another coordinate system.

APDL Command: ATRAN

Parameters
kcnto

Reference number of coordinate system where the pattern is to be transferred. Transfer occurs from the active coordinate system. The coordinate system type and parameters of KCNTO must be the same as the active system.

na1, na2, ninc

Transfer area pattern beginning with NA1 to NA2 (defaults to NA1) in steps of NINC (defaults to 1). If NA1 = ALL, NA2 and NINC are ignored and the pattern is all selected areas [ASEL]. If NA1 = P, graphical picking is enabled and all remaining arguments are ignored (valid only in the GUI). A component name may also be substituted for NA1 (NA2 and NINC are ignored).

kinc

Keypoint increment between sets. If zero, the lowest available keypoint numbers are assigned [NUMSTR].

noelem

Specifies whether elements and nodes are also to be generated:

0 - Generate nodes and elements associated with the original areas, if they exist.

1 - Do not generate nodes and elements.

imove

Specifies whether to redefine the existing areas:

0 - Generate additional areas.

1 - Move original areas to new position retaining the same keypoint numbers (KINC

and NOELEM are ignored). Valid only if the old areas are no longer needed at their original positions. Corresponding meshed items are also moved if not needed at their original position.

Notes

Transfers a pattern of areas (and their corresponding lines, keypoints and mesh) from one coordinate system to another (see analogous node TRANSFER command). The MAT, TYPE, REAL, and ESYS attributes are based upon the areas in the pattern and not upon the current settings. Coordinate systems may be translated and rotated relative to each other. Initial pattern may be generated in any coordinate system. However, solid modeling in a toroidal coordinate system is not recommended. Coordinate and slope values are interpreted in the active coordinate system and are transferred directly. Areas are generated as described in the AGEN command.