map

Mapdl.map(kdim='', kout='', limit='', **kwargs)

Maps pressures from source points to target surface elements.

APDL Command: MAP

Parameters
kdim

Interpolation key:

0 or 2 - Interpolation is done on a surface (default).

3 - Interpolation is done within a volume. This option is

useful if the supplied source data is volumetric field data rather than surface data.

kout

Key to control how pressure is applied when a target node is outside of the source region:

0 - Use the pressure(s) of the nearest source point for

target nodes outside of the region (default).

1 - Set pressures outside of the region to zero.

limit

Number of nearby points considered for interpolation. The minimum is 5; the default is 20. Lower values reduce processing time. However, some distorted or irregular meshes will require a higher LIMIT value to find the points encompassing the target node in order to define the region for interpolation.

Notes

Maps pressures from source points to target surface elements.