crplim

Mapdl.crplim(crcr='', option='', **kwargs)

Specifies the creep criterion for automatic time stepping.

APDL Command: CRPLIM

Parameters
  • crcr – Value of creep criteria for the creep limit ratio control.

  • option

    Type of creep analysis for which the creep limit ratio is specified:

    1 (or ON) - Implicit creep analysis.

    0 (or OFF) - Explicit creep analysis.

Notes

The CUTCONTROL command can also be used to set the creep criterion and is preferred over this command for setting automatic time step controls.

The creep ratio control can be used at the same time for implicit creep and explicit creep analyses. For implicit creep (Option = 1), the default value of CRCR is zero (i.e., no creep limit control), and you can specify any value. For explicit creep (Option = 0), the default value of CRCR is 0.1, and the maximum value allowed is 0.25.

This command is also valid in PREP7.